Hello,I need some information and configuration link to setup H.O with 3 Branch already connected via VPN for IP telephony using ATA 186/188. This is just a starting of the project and do not want to setup any voice gateway & call manager initially.I...
from the result below, what i am loosing?. what is the remedy for this?.Depot-rtr# show buffersBuffer elements: 1118 in free list (500 max allowed) 20206063 hits, 0 misses, 1119 createdPublic buffer pools:Small buffers, 104 bytes (total 50, p...
Dear friends,I have problem in my 1841 router connected point to point to another 1841 router. In one router i see thru monitoring tool lots of error generated on serial interface . attached is the image of that. how can i check what is generating th...
Hello I have a point to point 2 Mbps connection on 1800 router. When i check the serial link status it show bandwith 1.54Mbps.Can any one has an idea till what max. bandwidth is supported by WIC.? And what is the hardware for Bandwidth above maximum ...
Hello,I need the routing information for the two P2P-routers as shown in attached diag. The firewall is already configured with the route. SITE-B needs access to DNS, Active Directory, Fileshare and Internet from HO. What would be the routing in both...
Hi SushilI am also looking for 3cx solutions too. Is it possible to install 3CX at all the location and and let all the soft PBX talks to each other or it only support 1 PBX in the network
Hi Sushil,I have attached the diagram and placed 1860 too. let me know is this correct and what else or which part# of 1860 i would require. Does it still require Call manager Express?. The requirement is in proposal phase, i have to design, create B...
Dear Sushil,Thanks for the reply. Here are the details1. All 3 branches connects to HO Via VPN. The link is DSL with 2MB bandwidth2. one or two phone number at each branches is enough. 3. HO will have maximum of 3 IP telephony.So i think the requirem...