Hi I have seriuos problems trying to reset my UC540 to factory defaults,I followed the above instructions without look (maybe because my inexperience with the iOS) some of the commands worked and some others not, now I have only access to the UC540 v...

I was using for almost 18 months the CCA v3.x very well (upgraded two times the previous versions), 3 months ago and I started sharing configurations and settings with the Cisco SB Office Manager, yesterday after enabling the VPN for a user in the CS...

After upgrading my UC540 to v 8.6 I was finally able to use the iPhone as an IP phone, using the well documented configuration posted almost a month ago in this site I started using the iPhone, but the calls only last for 15 to 25 secs before droping...

For several months I've been looking for how to configure the Uc540 to accept iphones and how to configure the CISCOMOBILE App 8.1 (or the new Jabber) to connect to the uc540.Before, some people write that its not supported yet, but yesterday I noted...

For several months I've been looking for how to configure the Uc540 to accepts iphones and how to configure the CISCO App 8.1 (or the new Jabber) to connect to the uc540.Before, some People write that its not supported but now even in the cisco uc 50...