Does anyone have interoperability experience with Ciena 4200? Ciena profile minimum MTU value is 1600. Should I configure the Catalyst 6500 to match this value?
What value is indicated on the 6500 Gigabit port for the maxIndex value? The linecard is a WS-X6516-GBIC and SW ver 12.2.94. qos6Inlost = 095. qos7Inlost = 096. qos8Inlost = 097...
I have 5 WS-C3550-48-SMI switches on 2 different floors in a single building. There are 3 on one floor and 2 on another. There are 2 RPS 300 units (one for each floor). All 5 3550s are showing RPS is FAULTED with the show env all command.A visual ...
I have an issue with routing through the ACE module and need to disable session matching. Simple loadbalancing, but an old, bad network design requires a temporary fix.
I have multiple virtual interfaces on a single Cisco PIX physical interface (separated by VLAN tag), but MRTG shows all with the same data (in and out bandwidth). Is there a way to show separately with MRTG?
This sounds very familiar to an issue we had with DNS Fixup in PIX 6.35. The DNS maximum was set to 512 and we had to increase its default size. Perhaps the fixup value was not default before the upgrade and the value was reset.The suggested method...
If there is not an ACL already on the inside interface and if the inside interface has a higher security level than the DMZ interface, then all you will need is an address translation. Either a static or a nat statement.
Since I don't know the whole configuration, here are the standard VLAN/FWSM rules as refresher.VLAN Guidelines: You can use private VLANs with the FWSM. Assign the primary VLAN to the FWSM; the FWSM automatically handles secondary VLAN traffic.You ca...