I recently upgraded our CUC cluster from 22.214.171.12400-5 to 126.96.36.19900-14. Upgrade went fine and everything appears to be working. However, on my Publisher, the Connection Serviceability feature service is active but stopped. I've rebooted the Pub, still stopped. I've tried starting the service through CLI with utils service start Connection Serviceability, command failed. Service is running fine on Sub and I can access the cuservice page on both the Pub and Sub. Under cluster management, Pub is running as Primary and Sub as secondary. Anyone ever run into this? Should it be this way? If not, thoughts on resolving?
Also, Connection Administration was the same way after upgrade and reboot, but was able to start by simply clicking on the Start button. Haven't rebooted server since I manually started this service to see if it automatically starts.
... View more
We have the same issue using Mitel 5330IP phones on Cisco 2960X on 15.2(2)E4 software. IP phones show up in both vlans on some ports, but others show just the voice vlan. Using Port-Security, we have to set the max MAC addresses to 3 as well to resolve this.
We've started deploying 802.1x at sites. With the Mitel phones, as soon as the MAC address of the phone shows up in both vlans, the port shuts down into an err-disabled state. The phones are 802.1x capable, but I haven't had any luck having the them authenticate. From what I've read online, MAB is the only solution, but I have yet to test this.
We have 2 sites that have Cisco IP phones. With these I've read that the phone and switch use CDP and the switch moves the phone into the voice vlan. This works, but every now and then I'll see something weird happen. What happens is the phone shows up in voice vlan and then fails 802.1x authentication and gets moved into the failed authorized vlan and the phone then shows "Phone Registering" on the screen.
Have either of you seen something like this with the Cisco phones?
BR, have you had any luck in your 802.1X deployment?
... View more