I'm using various Cisco routers and switches. Cisco 2811, 1841 routers. Cisco 3560 switches. I'm using net-snmp tools in UNIX.The output below is snipped to show what's important. When I use snmpwalk I see interfaces with errors. When I use the Cisco...

I'm having trouble figuring out how to set up an AT&T OPTEMAN EVC in my home lab.Routers r1, r2, and r3 are connected to r0 by way of the OPTEMAN circuit but they're also connected r1<->r2 and r2<->r3 by the same OPTEMAN circuit. I'm imagining I can ...

I had an issue where EIGRP was choosing to route all traffic over a T1 instead of a 10 Mbit circuit. When I changed the router's ethernet interface connected to the 10 Mbit circuit from Half Duplex to Full Duplex the routes changed to use the 10 Mbit...

This Expect script provides expect with a list of IP addresses to Cisco IPS sensors and commands to configure Cisco IPS sensors.I'm having 2 problems:1. Sometimes the script appears to send the next command before the next prompt appears in which cas...

What does adding Qualys vulnerability scan data to MARS allow MARS, help MARS to do?Does it help MARS identify an alert as a false positive in the context of a host which Qualys says isn't vulnerable OR does it do something else like when the Qualys ...