About andymccall

andymccall · 01-12-2014

Hi Folks,I've got to the point where I'm thinking of giving up on the hardware I've got because I don't think it will work, which is strange as I would have thought for a small business this would be a common configuration, unfortunately it means I'l...

andymccall · 09-02-2012

Hi Folks,I'm trying to get an incoming POTS call to ring a single phone while studying for my CCNA Voice. At the moment I'm struggling and when I call the POTS number I'm getting a dial tone, I can then dial the internal extension, but I want it to ...

andymccall · 08-05-2012

Hi Folks,I'm trying to get a single 7970G phone to register against a 2611XM running CME 4.3 as part of studying for my CCNA Voice. I've done lots of reading around and come up with the config attached, but the phone I've got just sits at the Upgrad...

andymccall · 01-13-2014

I *finally* got incoming calls working today! Yes, no static route was needed. There were a few different problems.The only two things I have left to work on are:Calls coming in via SIP that are forwarded on noan to a mobile connect, but don't have...

andymccall · 01-13-2014

Thanks for the reply Carlo,I've attached the output of a debug ccsip messages, the call completed fine.At the moment when trying to make an incoming call nothing hits the CME at all, but I wasn't sure if it should as there are no static routes. Cal...

andymccall · 09-02-2012

Worked it out. My FXO port is 1/1/0, not 1/0/0 :-)

Member Since	‎08-05-2012 01:20 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	14

User Statistics

User Activity

Is SIP behind NAT possible with this hardware?

Help with FXO Incoming and Outgoing Calls...

Basic CME 4.3 Config Problem...

Re: Is SIP behind NAT possible with this hardware?

Re: Is SIP behind NAT possible with this hardware?

Help with FXO Incoming and Outgoing Calls...