setup: - ccm 4.1(3)- a call from pstn is forwarded to an external phone on the pstnI need to add a prefix to the CLID sent by the redirecting IP phone.This is working when I use the External Phone Number Mask, but not when using either the Transforma...
I have a 2611XM with NM-HDV2 and PVDM2-64 modules running on 12.3(8)T8.Question:Is this gateway supported to be configured as a DSP resource in CCM 3.3(3)ES73?I found in http://www.cisco.com/en/US/partner/products/hw/modules/ps5365/products_data_shee...
as far as I know at the moment on the 7940/7960 the 'missed calls' can be cleared only all at once.will the feature that an entry is removed if the number was called back be available in the future? if yes, when?
As suggested inhttp://www.cisco.com/en/US/partner/products/sw/iosswrel/ps5207/products_administration_guide_chapter09186a0080392682.html#wp1349195I need to configure transfer patterns to allow Cisco IP phones to transfer telephone calls from outside ...
http://www.cisco.com/univercd/cc/td/doc/product/voice/srst/srst33/srs33spc.htmexplains the limits for SRST 3.3:max-ephonesmax-dnWhat counts to the max-dn limit?If a phone has two lines, does this count 2 DNs automatically?Does an additional dial-peer...
Hm, still unsure whether the non-dynamic dial-peers count to somehow to the 'Maximum Ephone-dns or Virtual Ports' per platform as provided here:http://www.cisco.com/univercd/cc/td/doc/product/voice/srst/srst33/srs33spc.htmMeanwhile it looks like tha...
From your post I can see that you already completed the following:---snip---Reset to Factory DefaultComplete these steps:1.Go to the main Date/Time screen.2.Press **# to unlock Network Configuration on the phone.3.Press Settings.4.Press 3 on the keyp...
Which version of CCM are you using?With CCM 4.x you should be able to configure hunt groups as follows:1) in ccmadmin go to Route Plan >> Route/Hunt >> Line Groupcreate a Line Group and add the required DNs2) in ccmadmin go to Route Plan >> Route/Hun...
Have a look here:http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a008017278b.html#wp1079378If connectivity still fails, a look at the pix log might help ('sh log').
