Hello,
I've been struggling to get a Flex VPN Setup to work and I seem to be getting some problem.
Specifically - the static route for the subnet between the hub and spoke tunnel does not appear in the routing table of any of them.
Here is the ...
Hello everyone,
last year,around the end of summer I remember I saw a bulletin somewhere with a new feature being announced: stacking over Ethernet ports.
I was working at a customer and I remembered that feature and was wondering if the feature is...
Hi all, I'm having an issue with a couple of ESXi hosts connected to a 4507 switch. The hosts are connected with 4 GB links to to the switch, and the port channel is configured as trunk, with 5 vlans allowed, with onInterfaces:Gi1/25 ESX01 ...
Hello, I've been working on configuring Address Book Synchronization between a UCM V7 and Windows 7. I've taken all the steps required: - created the end user, associated with the extension; - installed the plugin on the local PC, - configured the p...
Wow. Yes, that's the problem.
It works now.
I'm posting my config here just for people to be able to use it.
Thanks and regards,
Gabriel
spoke-155#sh crypto ikev2 sa detailed IPv4 Crypto IKEv2 SATunnel-id Local Remote ...
Hello,
thank you for the suggestions:
- I did not have the AAA Commands,
- I have configured the FLEX-AUTH-POL-01 and the ACL on both the hub and spoke.
and the output for the "show crypto ikev2 sa detail" is as follows bellow. From what I see ...
Hi, thanks for this, but I allready knew it. Is there any other way to synchronoze the Windows 7 Contacs with the Cisco Personal Directory ?Thanks and regards, Gabriel