About yadavsandip

yadavsandip · 12-13-2013

1.) There is one layer 2 switch which is connected to one Active & one standby router of hsrp; which is also connected to LAN too...Active router replies behalf of virtual router but when active router fails how that layer 2 switch knows immediately....

yadavsandip · 02-22-2012

Hi,if i configure two 1-gig interfaces for etherchannel, after bundling two interface does etherchannel interface become (1+1) 2 Gig in actual.i heard Etherchannel interface becomes 2gig logically (as per this case) but in actual during data flow tim...

yadavsandip · 08-30-2011

Hi, it is 4507R-E having ios: cat4500e-ipbasek9-mz.150-2.SG.bin; previously its cpu utilization was 0 to 1%; suddenly it reached up to 58%; after searching i found its ios bug so upgraded ios to above mentioned one. after that still it shows 45%. I a...

yadavsandip · 12-14-2013

Thanks Jon n Alex...

yadavsandip · 03-26-2012

We are also facing same issue, on Cisco 2950. Users are unable to connect on 2950 but able to 2960. Actuall both 2950 n 2960 working fine with primary ACS, but 2950 is not working with secondary ACS (when primary get down) following are debug messa...

yadavsandip · 02-24-2012

Hi,Thanks all of U.

yadavsandip · 08-31-2011

Hi, What i know abt Dns is, it resoves ip to hostname vice versa; so how it is affected in ur case.

yadavsandip · 08-31-2011

Hi Swati, Thanx for ur response...in above doc, there is sentence like "Five-second CPU utilization is expressed as:x%/y%The x% represents total CPU utilization, and y% represents the CPU that is spent at the interrupt level. When you troubleshoot Ca...

Member Since	‎08-30-2011 10:34 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	8

User Statistics

User Activity

HSRP Question:

Etherchannel bandwidth

High cpu utilization in 4507R-E

HSRP Question:

dot1x authentication not working on 2950

Re: Etherchannel bandwidth

Clearing arp-cache

Re: High cpu utilization in 4507R-E