My R3 acts as a frame-relay switch connecting R1. The frame-relay circuit is up. However, R1 is unable to see R6 thru ospf routing. Attached here is the config & diagram to explain. Hope some1 can help this novice. Many thanks.

Hi all,I got the following error doing a debug on a frame-relay & couldn't find any doc that explain the problem. Hope some1 from here can help. The error as follow:"Serial0/1:encaps failed on broadcast for link 7(IP)"

Hi all,Has anyone encounter such error before? I am puzzled on who could have perform changes on my router.

Hi,I am on a ISDN dial to a remote router.I encountered a problem whereby I cannot see the LAN segment over the remote router when CEF & fast switching are enabled on both the dialer & gigaEthernet interface. However, when CEF & Fastswitching are dis...

Hi,I had recently requested an upgrade from my service provider on one of my frame-relay site. Is there a way to verify if an upgrade has been done on my pvc?Regards.