About Reza Rezazadeh

Reza Rezazadeh · 08-29-2009

I'm config two routers for ppp connection:Router1 : The configuration is attache.--------------------------------------Router 2 :The configuration is attache.----------------------------------These routers are connected to two PARADYNE 7975M/SDSL, on...

Reza Rezazadeh · 07-17-2009

For routing process I add a IP address of each Vlans subnet that active on each Access and Distribution switches (Have a port with that Vlan on the switch) to the corresponding Vlan Interface of them. Which IP address should I add to the Core switch ...

Reza Rezazadeh · 07-17-2009

I intended to create a LAN and examine VTP pruning on simulation status, but after set a vtp domain and vlans parameters, I can't run a command "vtp prun". The core device is 3560-24PS.When I use "vtp ?" only shows "domain, mode, password , version" ...

Reza Rezazadeh · 02-07-2009

Hello friends , I connect two LANs together with two Cisco 2600 with PARADYNE 7975 M/SDSL.I can telnet each of them trough another router.But computers that each side can't ping another side.LAN1 IP address is : 172.20.0.0 255.255.0.0LAN2 IP address ...

Reza Rezazadeh · 01-19-2009

Hello ,1- Is PARADYNE 7975 M/SDSL a CSU/DSU device ?2- Is this correct connect Router 2621/2610XM to 7975M/SDSL and the same at remote site to implement Frame Relay ?Thanks for your help

Reza Rezazadeh · 08-31-2009

Yes ,I'm connecting two routers with WIC,Where is missing in the routing part ?Thnak you

Reza Rezazadeh · 02-08-2009

Hello ohass,Thank for your help , "ip route 172.20.0.0 255.255.0.0 Serial0/1 ", from router2 is necessary. right ?here is output of :show ip interfaces brief Router1Interface IP-Address OK? Method Status Protocol...

Reza Rezazadeh · 01-19-2009

Hello ,1- Is this correct that connect Router 2621 to 7975M/SDSL and the same at remote site to implement Frame Relay ?2- I used another router 2610XM and connect to another 7975M/SDSL , but the same result .Thanks your help

Reza Rezazadeh · 01-19-2009

Hello Giuseppe ,I'm connecting S0/1 to DCE not S0/0. Please look at S0/1 status. Nothing is connect to S0/0, but I don't know what about in result.I use a same cable. EIA-530A-to-V.35.Information that you requested are attached.

Reza Rezazadeh · 01-03-2009

I thought that the problem is with 172.20.0.x hosts, hosts that the third octet is "zero" . how can I correct this ?

Member Since	‎11-16-2008 09:54 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	32

User Statistics

User Activity

PPP connection not start

Core layer switches IP address for routing

Packet tracer 5.1 and VTP pruning

Routing error

Is PARADYNE 7975 M/SDSL a CSU/DSU device ?

Re: PPP connection not start

Re: Routing error

Re: Connect DTE to DCE and Frame Relay

Re: Connect DTE to DCE and Frame Relay

Re: Access-list problem