Dear Members, can we configure stateful active-active configuration on cisco routers.i have two routers, to each router one mpls link from different ISP is connectedrouters are connected back to back and i want both isp links shuold be utilisedcan w...
Dear Members,
I had one typical problem. We have IBM blade center HT chassis.
Four blade servers are used form this chassis, connected to BNT switches and in turn BNT switches are connected to cisco 4948 switches.
I am unable to ping default gate...
Dear Memebers,
I had two cisco 4948 switches. Both are connected back to back on Gi 1/2 and Gi 1/3 ports.
In Switch B i got complaint of cHsrpstatechange. when i logged in and checked in the switch i found following error in swicth B.
003545: O...
Dear Members,
I am getting follwoing errors continuously in ths switch.
Gi 1/43 and gi 1/42 is uplink access ports for vlan 101 and vlan 111
config is follow
interface GigabitEthernet1/42description Uplink VLAN101switchport access vlan 101switchp...
Dear Members,
There are two cisco 4948 switches. both are connected back to back also on two ports.
we got an alarm Cisco-equip:cHsrpStateChange:
The ip address is related to second switch.
i checked and found hsrp states are ok.
active in one swi...
Hi,
Two switches 4948 are connected back to back on ports gi 1/1, 1/2, 1/3 & 1/4 only.
Ports gi 1/42 & gi 1/43 are connected to some servers. These ports are access ports and not trunk ports.
Hi,
If we check for vlan 103 it is changing.
Please ref below it changed in last 05:35 hrs
Vlan103 - Group 104 State is Standby 327 state changes, last state change 05:35:00 Virtual IP address is 1XX.28.10.236 Active virtual MAC address is 0000.0...
