fabienfs
Level 1
Level 1
Member since ‎12-20-2014
‎12-24-2020

User Statistics

  • 39 Posts
  • 1 Solutions
  • 20 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
1 Helpful Vote
1 Accepted Solution
20 Replies
10 Replies
5 Replies

User Activity

Hello,I have a router Cisco ASR1001 that rebooted on its own last night and I don't know the cause.How can I find a log of what happened? I tried with "show log" but I only have recent logs from the last minutes.I also looked at the alarms "show faci...
Hello, I have a switch Cisco SG300 (in L2 mode, in last firmware version) with 3 VLANS. I defined an IP address on my VLAN 41 for switch management (Web gui acces, ssh, ...). My problem is that I can't seem to set an IP on my other two VLANs. For exa...
Hello,When I boot my Cisco ASR1001, I have this message : The boot then proceeds correctly. Should I be concerned about this error?%IOSXEBOOT-4-FILESYS_ERRORS_CORRECTED: (rp/0): bootflash contained errors wich were auto-corrected The boot then procee...
Hello, I use access-list to restrict access to telnet.How to adapt this rule to also restrict telnet access in IPv6?  access-list 50 remark ---Restrict Telnet Access--- access-list 50 permit xx.xx.xx.xx 0.0.3.255 access-list 50 deny anyDo I need to a...
Hello,I have a critical led that lit up on my ASR1001.With the command "show facility-alarm status", I have this :  System Totals Critical: 4 Major: 2 Minor: 0 Source Severity Description [Index] ------ -------- ...
Community Statistics
Member Since ‎12-20-2014 12:31 PM
Date Last Visited ‎12-24-2020 03:37 AM
Posts 39
Total Helpful Votes Received 5
Helpful Votes From
Helpful Votes Given To