About Q S Tahmeed

Q S Tahmeed · 03-29-2016

Hi Forum, In recent time we observed that one of our routers CPU has spiked abnormally. Even though the amount of bandwidth passing through the Router has increased but its no where proportional to the spike in the CPU. About two weeks ago the over...

Q S Tahmeed · 05-01-2012

dear All, i have come accross this following network scenario and got kind of stuck. The Service Provider is connecting two remote sites of its customer with customer's head office. Requirement of the customer is to provide them Trunk Links to all th...

Q S Tahmeed · 03-18-2015

Hi, You can prepend prefixes towards your ISPs. Suppose prefix X is transmitted via ISP-A. In that case you announce prefix X towards ISP-A without any prepending and towards ISP-B with prepending, using your own AS at least more than 2 times. This ...

Q S Tahmeed · 03-11-2015

Hi,The diagram is a bit confusing for the remote office. However, if you have a router that peers with MPLS provider at remote end then instead of other things I would suggest to set up GRE and peer with your remote router using OSPF. Then you will ...

Q S Tahmeed · 06-11-2012

dear All, it was later found that the issue arised due to low quality Fibre Optic media converter at Head Office end which simply couldn't handle the load. after replacing it with a better pair the issue is resolved. Thank you all for you time and ef...

Q S Tahmeed · 05-01-2012

hi! jwbensleyi haven't been able to trace DHCP requests through out each hop in the network but will do that. and yes the servers are at HQ. and i am sure that there is no loop in any of customer's sites. however STP is running at each of the Custome...

Member Since	‎04-30-2012 11:57 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	9

User Statistics

User Activity

Cisco 7606: High CPU

QinQ & MPLS Layer 2

Hi, You can prepend prefixes

Hi,The diagram is a bit

Re: QinQ & MPLS Layer 2

Re: QinQ & MPLS Layer 2