jkwakman
Level 1
Level 1
Member since ‎10-17-2002
‎08-01-2018

User Statistics

  • 13 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies
Certifications

User Activity

When we setup a connection between two hosts we receive the message "TCP checksum incorrect" , This is  between a settop box on the outside and a server inside the firewall. This STB used to communicate with the server on port 443 which is NAT-en to ...
Last night I've upgraded a catlyst 6509 (non-redundant), during the upgrade I run into the problem that the 6509 only wants to boot from sup-bootflash, and that it took an old image from sup-bootflash.I deleted this old image and then the node came i...
The catalyst 6509 in our mediafarm is running an old release: s72033-pk9s-mz.122-18.SXD3.bin.This catalysts has a firewall module and a loadbalancer module in it.We run about 400Mbps multicast traffic in vlan550 for our TV service, this traffic shoul...
I'm receiving multicast traffic (400Mbps) on port 9/38 and sending it out on port gi9/48I'm trying to achieve that traffic will stay within the card without using the switchfabric,  Am I succeeding in this, please see attached file
We receive syslog warnings that we run  to the threshold for the maximum supported mpls routes in the CEF table, below some information.What is the impact/risc if the threshold is exceeded?What is the service impact when increasing the settings?What ...
Community Statistics
Member Since ‎10-17-2002 09:37 PM
Date Last Visited ‎08-01-2018 02:27 AM
Posts 13