Hello,I just acquired a 2811 running IOS 12.4, but I cannot run the access-group command simply because it doesn't exist. Has anyone experience this before. I can run access-list no problem, but access-group is not existing. Please help me.Thanks
Why would cisco sell L2 only interfaces to plug into a router? A router is supposed to do L3, right? It doesn't make sense to me!Now I'm stick to 4 L2 ports, and there is no way to software-upgrade it.Thanks for your lightMujos
Right Narayan!Fa0/0 indeed supports the command access-group!so this means that my Four (non-default) Ethernet ports cannot be configured with routing commands!! How can I turn them to L3Attached is my 'sh diag' resultThank you for your help!Mujos
So the problem must be the flash version? This means its a bug in my flash then, how can brand new router with IOS 12.4 not be able to run the basic access-group command?Anyway please help me to clarify this, and the exact action to take to solving t...
Hi Sundar,How can an interface on a router be Layer 2? Althought I think my interface in L3, is there a command to turn it to a L3? How can you see that?Thanks for your light!