About c.hodges

c.hodges · 06-22-2012

I just got a used 3005 VPN Concentrator and I can't get a console session established. I use the standard blue Cisco flat cable (DB9 one end Rj45on other) I can plug this into any Cisco switch, router or ASA and get a console prompt. The 3005 has a m...

c.hodges · 02-12-2009

I have a Pix with a blank running config, I can load the 7.2 from Monitor mode OK, when I try to then get the 7.2 .bin file tftp-ed to the PIX and saved in flash it gives me a "no route to host" errorPix E1 172.23.4.125 255.255.255.0laptop 172.23.4.1...

c.hodges · 02-13-2009

Yes, I can get it to load and run 7.24 from monitor mode. but according to the instructions you are running from RAM and you have to then tftp the IOS again and save it to NVM ram -flash. That is when I have the problem, I can't get the PIX to conne...

c.hodges · 02-13-2009

I did a no shut on the interface, no routes in the route table but the laptop is directly connected to the interface so I didn't think that required any routes.. ??still the same ... no route to host

Member Since	‎02-12-2009 03:36 PM
Date Last Visited	‎05-22-2019 12:07 AM
Posts	4

User Statistics

User Activity

Cisco 3005 VPN Concentrator - No console?

Pix515E upgrade from 6.3 to 7.2 -"no route to host"

Re: Pix515E upgrade from 6.3 to 7.2 -"no route to host"

Re: Pix515E upgrade from 6.3 to 7.2 -"no route to host"