Hi Guys, Appreciate if any of you could help me to solve this problem..I've just bought WAE-7326-k9 WAE and tried to load the full image from recovery CD (download from cisco) but during half way the program just stop with this error.. M...
Hi Guys, I'm not very familiar with this card, I have this problem , when i type sh ip int brief ;rtr2#sh ip int briefInterface IP-Address OK? Method Status ProtocolGigabitEthernet0/0 1...
Hi! Need some expertise help here, one of our 6500 switch having hi CPU utilization when i do sh proc cpu.:****************** show proc cpu ******************CPU utilization for five seconds: 66.82% one minute: 24.54% ...
Hi ! Any body encountered b4 ? When directly console in to the 6513 is ok but when telnetting to it ,it's display garbage, I've swapped the terminal server cable to the other core it's working fine (to confirmed the cable and the terminal server i...
Hi ! really appreciate if somebody has this solution/ever encountered this problem:-Wan conncations point to point================================I've one side cisco router with wic 2T serial card the others side is VWIC2-MFT-T1/EI ehich is second ge...
I have tried to install from all 4.0.X version families still could not go through until i tried next major release Version: 4.1.3b Build: 9 then managed to install successfully.. thanks eric for the clue...case close..
option 2 is to prepared the flash already done but cookie failoption 3 fail due to unknown modeloption 3-5 is just to copt sysimage to flash..option 6 for future option..option 7 that's where i stuck..option 8 exit..all tried... in fact i've tried d...
Hi Yesua, The router is 3825 running ios ver Version 12.4(1c), config i believe is correct.....card type e1 1card type e1 2card type e1 3....!controller E1 1/0 line-termination 75-ohm channel-group 0 unframed!controller E1 1/1 line...
bosalaza, Yes I taught that contribute to the problem, but after I've disable it, the output is still high, around 40 - 80+ % fluctuate and yes also I've done the sh tech prior to do the sh proc cpu, will try to reboot the sup, earlier one o...