About ericdude101

ericdude101 · 02-10-2017

Is it possible to lock down a device so it will only respond on a specified IP address and be transparent on the rest? For example: Say I have a switch operating at layer 3 with 3 VLAN's and corresponding interfaces in each for routing purposes, V...

ericdude101 · 02-13-2017

So basically I would need to create one ACL to block ssh, telnet, tftp, http, and https and apply that to each SVI that i dont want management access on.

ericdude101 · 02-12-2017

The control-plane command is not found. I did create am ACL and apply it to the VTY lines as shown below: ip access-list extended VTY_ACCESS 10 permit tcp any host 10.0.255.1 eq 22 100 deny ip any any log After doing this all connections are refuse...

ericdude101 · 02-11-2017

I attempted to issue the control-plane command and it appears it is not part of the 3750x base IOS, also if I were to use either of these methods, I would need to create an ACL and apply it directly to each of the VLAN interfaces on the switch correc...

Member Since	‎01-03-2017 03:40 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	4

User Statistics

User Activity

Management Restriction

So basically I would need to

The control-plane command is

I attempted to issue the