About shamsugrace

shamsugrace · 02-21-2013

One of customer has two departments Marketing and Admin. All Marketing extensions are starting with 100 series (101, 102, 103 etc) and All Admin extensions are starting with 200 series (201, 202, 203 etc).There are ten PSTN Connections, Six for Sales...

shamsugrace · 01-26-2013

I am facing an issue while installing the the SGE2010P switch with UC560. There are two switches in the site one SF300 and SGE2010P. The SF300 is working fine. But the SGE2010P switch is making issue. I connected the UC560 to the SF300 directly and c...

shamsugrace · 07-09-2021

upgrade the FTD to release 7.0. You can configure DAP directly

shamsugrace · 08-25-2014

NAT. You have to configure the ip nat outside and ip nat inside on the corresponding ports of the router. Then create an ACL for your local broadcast domain as permit and do NATing with a default ip orute.

shamsugrace · 08-25-2014

1. Cisco ISR: (integrated Service Routers): typically used as internet edge forcustomers with small/medium networks.2. Cisco ASR (Aggregation Services Routers): typically used as internet edge forenterprise networks and service providers...

shamsugrace · 09-08-2013

Any seperate license required for this?

shamsugrace · 02-22-2013

Hi Tom,Thank you for your prompt reply..I fixed it

Member Since	‎01-26-2013 01:18 AM
Date Last Visited	‎07-13-2021 07:20 AM
Posts	6
Total Helpful Votes Received	21

User Statistics

User Activity

UC560 - Trunk Group

SGE2010P switch configuration

Re: Dynamic Access Policy (DAP) for AnyConnect work around on FTD

NAT. You have to configure

1. Cisco ISR:

Re: Configuring Cisco Jabber for iPhone with CCA 3.2.1 - UC500

SGE2010P switch configuration