Hello, when I create a report and try to email it to myself (or any email) I am getting a 10011 error "contact system administrator". I have the mail params config'd with my username / pass / mail domain / mail server...all correct. I can do expor...
1200 AP latest Vx firmware. ACS appliance. Dell Inspiron with 0n-board 802.11b card running windows XP SP1. I can get PEAP to work with the ACS local database but not with NDS. Authentication fails. Anybody else have any problems with NDS Externa...
In mapping out an 802.11a WLAN with many APs, What is the best Channel Assignment Scheme to use? What must the separation be between channels in adjacent cells? 802.11b is a 5 channel separation, What about 802.11a?thanks,Frank
It appears the Nortel phone system operates at 1.92gHz range. It seems like there should be enough separation between the freqs, but has anybody installed the two systems side by side? any problems or issues?Thanks
This is a point to multi point bridge environment. The root has an Omni and the others have directional ants. There are 3 non-root locations. 2 of the three are the following distances: 400 ft and 1.2Miles, they are connecting, but with lower sign...
I had a similar request for a backup and used the dialer watch to trigger the backup interface to come up. Check out http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_c/dcdbakdw.htmThis method watches a specific route in ...
12dBi Omni at the Root. I have RF Line of Site to all the locations. Other antennas can be seen with the naked eye. Root is in a small city environment, there are alot of other ants in the area but the carrier test is not showing very much noise...
I got the numbs from the cable guy. Obviously I lack where the cable starts out to the ant. I have a pic of the cable markings and can e-mail it to you if you send me your email [ frank.capra@us.logical.com ]. The markings on it say "84147 Andrew...
I feel like I have exhusted the possibilities on the cable, although the connectors could be causing the issue. Does anyone know if I can use an RF amplifier to boost the signal to a stable level? I am getting mixed opinions on this. The company t...