Having issues getting service profile to apply to blades. I have a MAC pool defined, but it did not ask me for this when creating template for serv profile. Any ideas on how to get this template applied to a server pool?
Manish,I also wanted to add to this post that if you SSH into Fab Interconnect and do a show ethernet 1/x that you may see an MTU size listed here of 1500, even though you may have, say, NFS traffic going over an appliance port and vNIC's configured ...
Thanks for input. Long story, but the reason the VEM was still showing up is because the host was still on line. My bad. It should have been deleted as was not.
I have a vem out there from an ESXi host that no longer exists. When I issue thiscommand I get:* this terminal sessionswitch(config-vem-slot)# sh mod vem mappingMod Status UUID License Status--- --...