mheusinger
Level 10
Level 10
Member since ‎02-18-2002
‎08-18-2017

User Statistics

  • 2087 Posts
  • 147 Solutions
  • 34 Helpful votes Given
  • 2695 Helpful votes Received
Recent Badges
50 Accepted Solution
15 Accepted Solution
1 Accepted Solution
5 Accepted Solution
50 Replies
20 Replies
10 Replies
5 Replies
100 Helpful Vote
 30 Helpful Vote

User Activity

Hi community,is it possible to see the clock rate configured on the DCE side on the DTE side of a serial interface?Regards, Martin
Hello,what is the purpose and effect of the commandRouter(config)#rate-limit llq-classifyObviously it is undocumented, but I have a question at hand, why this command is in a router config and what it does.Thank you in advance.Martin
Hi,is it possible to send VRF traffic down a specific MPLS TE tunnel, which does terminate only on ONE of two PEs?So f.e. CE1 - PE1 - core1 - core2 PE2 - CE2 and a MPLS TE tunnel from PE1 to core2. Can we send only traffic from CE1 to CE2 down the TE...
Hello,I have found in some "show policy-map" output that there are more packets marked (264500) than packets counted (261152)!?! This happens with an input policy not with output queueing, where I would understand it.Router#show policy-map interface ...
Hi, can anyone point me to a doc of the internal BGP selection process in a PE? To be more specific: In case you have a matching import RT, one would assume, that a route will always show up in the routing table of the according VRF (assuming proper ...
Community Statistics
Member Since ‎02-18-2002 07:35 AM
Date Last Visited ‎08-18-2017 03:51 AM
Posts 2,087
Total Helpful Votes Received 2695