rwharris13
Level 1
Level 1
Member since ‎03-23-2012
‎08-18-2017

User Statistics

  • 34 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
1 Helpful Vote
20 Replies
10 Replies
5 Replies

User Activity

Running 15.4(2)S on the ASR 901. Trying to do a simple NAT in my lab. The problem I'm having is that the host directly connected to the router doesn't NAT but if I source a ping from the inside interface it NAT's just fine. Both are on the same netwo...
I had a 7206 router that I was trying to replace with a 2951 with an NM-1T3/E3 module. When I move the DS3 to the 2951 the DS3 will not come up. To my knowledge there's nothing essentially different from how these two are configured so I'm not sure w...
I'm not sure what I'm even looking to do can even be done but here's the scenario.Router A advertises a default route to all ospf nodes with the "default-information-originate always" commandRouter B connects to router A and to Router D Router C conn...
I was reading through the different IP Precedence values and most seemed to be fairly straight forward, but I'd like to make sure I have my facts correct. According to the list below, IP Precedence treats traffic lowest to highest priority with numbe...
Hello, I'm looking for some direction, if possible, on what I beleive needs to be some PBR done to create the following scenario:2 ISP's connected to a 4507, both with seperate public IP blocks. Based on some source IP addresses on the LAN they would...
Community Statistics
Member Since ‎03-23-2012 06:13 AM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 34
Total Helpful Votes Received 5
Helpful Votes From