About lrbrown

lrbrown · 08-09-2004

When configuring a 3640 to load the ios from slot0, is it nessacary to specify the file name, even if it is the only file on the pcmcia? Or will it suffice to just enter" boot system flash slot0"?

lrbrown · 11-14-2003

I have a 2610 that requires an IOS upgrade. The ios requires me to increase the Dram on the box. It currently has 32 meg, and I will be upgrading to 64meg. I have recieved the upgrade, MEM2600-32U64D=, but am still a little fuzzy as to what I have an...

lrbrown · 07-31-2003

I have a scenario that a client is using Exceed, by Hummuingbird, to manage a number of our servers remotely. we are natting them, as they come in. I have 2 static nat entries, and a pool of one address with the overload command. The two static devic...

lrbrown · 10-31-2002

using a 2621 and a number of acl's and static routes, I was forced to compress the config to save it. My question is, what is the compression ratio? Also, is there a way to up the NVRAM to something above the 32k that it comes with?ThanxLB

lrbrown · 09-11-2002

I am currently trying to route vlan1 and vlan2 of a 2950 through a 2621. the 2950 is running ios 12.0(5.3)ws1 and the 2621 is running (c2600-js-m)12.1(9a).The native vlan on both devices is vlan1 and I'm using 802.1q, as that's the only encapsulation...

lrbrown · 08-09-2004

Paddy,Thanx for the info. The current image is loaded into internal flash. I have the new image on the pcmcia flash, and it's the only image on it. I entered the boot system flash slot0 command, and the router took it, with out specifying the file na...

lrbrown · 07-31-2003

That is what I thought it was, Have you had the same situation? I ask this, because we are running into exceed, more and more, and for planning purposes we just may need to use static nat for all remote site. Because some day a site may decide to use...

lrbrown · 11-01-2002

Thanx for the input. I did some polking around on the "boot buffersize" and from what I see, I can store the config in flash, if there's enough room. you have to change the boot statement to reflect that the config is now located in flash. I'll give ...

lrbrown · 10-31-2002

I've never used that command. How will it help? will it allow me to increase the NVRAM size?

lrbrown · 09-12-2002

I beleive I have corrected the problem, albeit, not the way I would have thought. I decided to configure the 2621 fastethernet0/0 the same way you would if I were using ios earlier than 12.1(3)t. I removed sub interface fastethernet 0/0.1 and gave th...

Member Since	‎03-05-2002 04:50 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	15

User Statistics

User Activity

Load flash from slot0

Question on 2600 DRAM UPG

Using Exceed and using Dynamic Nat

2621 and service compress-config

routing vlanswith 2950 and 2621

Re: Load flash from slot0

Re: Using Exceed and using Dynamic Nat

Re: 2621 and service compress-config

Re: 2621 and service compress-config

Re: routing vlanswith 2950 and 2621