About jlkeys

jlkeys · 11-15-2012

Has anyone had any luck getting smart tunnels to work in IE 10 on Windows 8? Whenever I click on a link setup to run a smart tunnel, I get an message saying that Internet Explorer has stopped working, then it attempts to reload th...

jlkeys · 10-02-2007

We have two locations, separate VTP domains, with separate VLANS. These two locations are currently tied together via OC3 and a 7200.My question is, if we were to convert our OC3 connection over to metroethernet, would we be able to route between th...

jlkeys · 11-12-2019

Did you have any luck finding an answer? I've been searching as well and haven't run across anything in the documentation yet.

jlkeys · 05-03-2016

You're creating the NAT for the source on port tcp/6000, so the service object would need to be set to source instead of destination: object service SERVER1-TCP-6000 service tcp source eq 6000 nat (INSIDE,OUTSIDE) source static SERVER1 interface ser...

jlkeys · 05-03-2016

Your NAT statement looks good to me, but you may need to change the order so the dynamic statement will happen last (the rules are processed from the top down): nat (INSIDE,OUTSIDE) source static SERVER1 interface service SERVER1-TCP-6000 SERVER1-TCP...

jlkeys · 12-05-2014

I have also noticed this and haven't ran across an equivalent match-all command. Has anyone else ran across this?

jlkeys · 01-13-2014

Here is an article someone wrote earlier, maybe it will help:https://supportforums.cisco.com/community/netpro/security/vpn/blog/2011/04/25/ipsec-vpn-redundancy-failover-over-redundant-isp-links

Member Since	‎10-24-2006 08:17 AM
Date Last Visited	‎01-28-2022 01:48 PM
Posts	26

User Statistics

User Activity

IE 10 (Windows 8) using Cisco Smart Tunnels

Metro Ethernet Routing

Re: Cisco 9K Scheduled Upgrade using Install Mode

You're creating the NAT for

Your NAT statement looks good

I have also noticed this and

Site to Site VPN's 2 ISP network redundancy