Is there a way to change the display name shown when in a multi-point call on an MCU? Currently it shows the h.323 ID, I am wondering if it is possible to show the SystemUnit name?
Currently have a cluster of three MSE 8510 blades running 4.3 and our media port mode is HD, allowing for 60 HD video ports and 60 audio ports.We just had a conference where the MCU would not allow any more than 80 participants (it was a mix of audio...
Saurabh,I made the change and it changes on the upper left hand corner of the home screen. But when I put the endpoint in a call, it still shows the h.323 ID.
Martin,Thanks for the quick response. To answer your questions:-We have our participant limit set to nothing-As far as setting the conference up differently, no we have not done that, we utilize TMS to schedule our calls, we currently have port res...
Ravi,I have turned CEC mode on, with the same result. I forgot to mention that if you unplug the HDMI cable and plug it back in the video is restored.I have not hooked up a different monitor because the output of the codec goes to an RGB Spectrum 3...
