Exert taken from Cisco document "Quality of Service Options on GRE Tunnel Interfaces"http://www.cisco.com/en/US/tech/tk543/tk545/technologies_tech_note09186a008017405e.shtmlNOTE: I have ran across several instances where we couldn't apply the service...
For switches with the POE capability, here are just a few of the current switches that cisco carries that supports POE, total available power, and how many interfaces you get with each model. Hope this helps.2960C-8PC-L8 x 10/100 Fast Ethernet w/ POE...
My recommendations. If port Fa0/24 on the 3550 was turned into a layer 3 interface and is not a switchport, there should not be a vlan or SVI created for the IP address subnet assigned to that layer 3 interface. The ip address should still be configu...
My recommendation. Make the core's uplink interface connecting to the firewall a layer 3 interface. assign a /30 subnet to that connection and configure the inside interface of the firewall for one of the two ip's. Then configure 'ip routing' on the ...
Heres my recommendation. Cores, distribution, and edge routers will all be in one autonomous system (i.e. it looks like you already have AS 200 for the cores, just extend to the other routers). Make the Distro's be the route reflectors for your edge ...
