My uplink port changes to orage when copying large amounts of data to a server on that switch, and since thats the uplink port, no servers on that switch will respond. If I unplug the uplink crossover cable and plug it back in, it changes back to gr...
Uplink port changes to orange after 12-36 hours switch stops respondingIf I unplug the cable from the uplink port and plug it back it, the switch starts responding again.What could be causing this?
I put in a new 2960 it went out after 12 hours, I put in another new 2960, it went out after 12 hours, I power cycled it, then about 12 hours later it went out again.What could be causing this?
Thanks!On the first switch its:show run interface GigabitEthernet0/1Building configuration...Current configuration : 49 bytes!interface GigabitEthernet0/1 duplex fullendon the second switch its:show run interface GigabitEthernet0/2Building configurat...
The information presented does not allow to finally conclude a certain reason. Could you provide the interface configurations? >>What command do I type to get the output you are looking for?Have you checked cabling as well? >>Yes, I even tried a new ...
Here they are:The log on the switch in cabinet #1 is saying:8w2d: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed state to down8w2d: %LINK-3-UPDOWN: Interface GigabitEthernet0/1, changed state to down8w2d: %LINK-3-UPDOWN: ...