About scott.hartlaub

scott.hartlaub · 01-13-2012

I am very interested in tuning my ASA Threat-Detection configuration. I desire for the device to shun addresses quicker for ACL failures and IP scanning. Any advice would be most appreciated.

scott.hartlaub · 04-25-2008

I have been unable to schedule recurring reloads on my WAN routers. Any suggestions are very much appreciated: kron occurrence RELOAD at 00:01 Fri recurring policy-list RELOAD kron policy-list RELOAD cli reload after running, the router drops cli ...

scott.hartlaub · 01-13-2012

That was it! Thanks Julio!

scott.hartlaub · 01-13-2012

Hello Julio,I have the following configuration and it does shun properly, i just want to tune it to shun faster.threat-detection rate dos-drop rate-interval 600 average-rate 100 burst-rate 400threat-detection rate dos-drop rate-interval 3600 average...

scott.hartlaub · 04-25-2008

No, I'm constantly typing wr mem:)

scott.hartlaub · 04-25-2008

Thanks. It does ask to confirm, and i figured that was the problem. I was hopeful there was a work around. Thanks again.

scott.hartlaub · 12-28-2007

I had the basically the same type of question a while back, because i was receiving warning messages regarding licensing. It keeps telling me we are over our limit of 500 licenses, when i only have 250 users. The response i received from CISCO was ...

Member Since	‎05-17-2007 08:53 AM
Date Last Visited	‎06-19-2018 10:50 PM
Posts	7

User Statistics

User Activity

Threat-Detection Tuning - How do you tune yours?

Using Kron for Reload

Threat-Detection Tuning - How do you tune yours?

Threat-Detection Tuning - How do you tune yours?

Re: Using Kron for Reload

Re: Using Kron for Reload

Re: Anti-X license