Hi, On our SSL Anyconnect client VPN set up we have a split tunnel configured to route all traffic for corporate network over the VPN and all other traffic over the local internet gateway. I added a URL's public IP address to the split tunnel with vi...
Hi all, I am trying to set up an IPSec tunnel with our telco who using a vcloud air. It has very limited capabilities in regards to IPSec. Below is config our end :- group-policy NSL-VPN-IPSEC internalgroup-policy NSL-VPN-IPSEC attributesvpn-idle-t...
Hi, I've been doing some remote packet capture on a CISCO1941/K9 , on the capture noticed no mac-addresses.
When I do the below , the router does not seem to have a 'match' feature.
AAA_R01#monitor capture buffer AAA ? circular Circular Buffer cl...
Hi all,I am working on setting up a home lab. I have an ISP wireless modem connected to a cisco 2811router. I've done a static route from the cisco router to the internet via the modem. I can ping 8.8.8.8 but cant ping anything else. Does this mean t...
Hi RJI, Yes there was another rule that was matching 1st.I moved the rule above it and it is now working. Many thanks for your help on this appriciate it. Kind Regards,
Hi RJI, Thanks for replying. I saw the error on the NAT too .. so I have amended to the below :- nat (Inside1,WAN1) source static DM_INLINE_NETWORK_106 DM_INLINE_NETWORK_106 destination static NSL-IPO-Remote-Network NSL-IPO-Remote-Network no-proxy-a...
Hi RJI, Many thanks for your reply. Unfortunately on the ASA ikev1 policy I cant change hash to to sha256. Also isakmp phase 1 is up IKEv1 SAs:Active SA: 1Rekey SA: 0 (A tunnel will report 1 Active and 1 Rekey SA during rekey)Total IKE SA: 11 IKE P...
Hi, I have configured the router with that but for some reason NIC on my PC (laptop) doesnt accquire any ip form the DHCP. I am connected to the router via a switch. I have a default gateway in the switch as the LAN interface of the router.