About tomtom2211

tomtom2211 · 01-15-2012

Hi,i have a strange issue with an HSRP Setup. I have two (S1+S2) 3560 as Core/Distribution Layer. Inter-vlan routing are enabled on both Switches. S1 and S2 are connected with an etherchannel over four fibre ports. S3 -S5 are the (L2) access layer...

tomtom2211 · 01-17-2012

Hi,the problem is now solved. I've add a HSRP Setup for Gi0/1 on S1 nd S2 (192.168.99.4).And on the firewall:up ip route add 10.2.0.0/16 via 192.168.99.4 dev br0Now, the net flow works as expected. Thank you very much.

tomtom2211 · 01-16-2012

Akshay, Rick,first of all, many thanks for your detailed reply.My apologies for any confusion.Ok, the network setup looks fine, but the firewall seems to causing the problem.The routing table on the firewall, as requested:linux-firewall:~# ip route l...

tomtom2211 · 01-16-2012

Hi,sorry, i misunderstood your answer.If there is no standby/HSRP configured on the Gi0/1 port then why would you expect it to not be active?And - yes, the posted HSRP setup for Gi0/1 is nonsense .. *shame on me*I am not sure what advantage you will ...

tomtom2211 · 01-16-2012

Rick,many thanks for this answer. I have never tought about on HSRP for the Gi0/1 ports. Your answer seems to be the right solution.I think, i have to add the following commands ... right?# Active Switch #S1# configure terminalS1(config)# interface g...

tomtom2211 · 01-16-2012

Hi,i have used thisTutorial from Cisco for the initial setup: http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a008015f17a.shtmlAdditional, i add a second switch and add HSRP.S1#show standby briefInterface Grp Prio...

Member Since	‎01-15-2012 02:12 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	6

User Statistics

User Activity

HSRP, routing issue

HSRP, routing issue

Re: HSRP, routing issue

Re: HSRP, routing issue

HSRP, routing issue

HSRP, routing issue