About sabbinanti

sabbinanti · 11-09-2019

I have no idea why I can't get these two ASA is. Please find the attached Config. I have listed them as ASA A and ASA B. ASA A is a 5508X and ASA B is a 5506X. Some of the IP addresses have be obfuscated. Number have been replaced with letter...howev...

sabbinanti · 10-25-2013

I can dial the Exchange UM from any SCCP phone and it answers. I setup a translation profile to translate redirect called. I just cannot get it to work. Any help would be apprciated. Please see config and debug infor below.Exchange 2010 SP2CCME 8.6T...

sabbinanti · 03-06-2013

I have two sites, one with a UC560 an another with a UC540. I manually created a VPN tunnle and setup dial peer. The two sites can use 4 digit dialing and have access to the PSTN from each site. Calls from IP Phone to IP Phone work just fine.However,...

sabbinanti · 03-22-2010

Armed with an ASA 5505 Security Plus, I have setup IPSec VPN for RA. The VPN IP Address pool is in the 192.168.2.0/28 network.The Lan is 192.168.1.0/24 with the inside interface at .254.The VPN works fine. What I would like to do is route all interne...

sabbinanti · 11-09-2019

Thanks for the response. Between them is the public Internet. I can run IPSec VPN (RA) through each Firewall. So I don’t think there is anything blocked. Thanks in advance.

sabbinanti · 10-26-2013

Self Resolved.Changed the Session Target port to 5065 for Exchange UM.

sabbinanti · 03-09-2013

Still doesn't work. Any Debugging I can try?Thanks,S.

sabbinanti · 03-09-2013

I think I already have that set as the primary codec. Please view belowUC540:dial-peer voice 2205 voip description to Conference Bridge destination-pattern 707[1-2] session target ipv4:10.10.200.250 voice-class h323 1 dtmf-relay h245-alphanumeric fa...

sabbinanti · 07-14-2012

Can you provide the running config for both swithces? All that is needed the the config for the interface on switch 1 connected to switch 4 and the config for the interface on swich 4 connect to switch one. Regards,Sebastian

Member Since	‎03-22-2010 09:16 PM
Date Last Visited	‎05-06-2020 12:33 AM
Posts	9
Total Helpful Votes Received	5

User Statistics

User Activity

Unable to bring up Site2Site VPN on 2 ASA's both running 9.8(2)

CME 8.6:SIP PSTN Trunk Cannot forward to Exchange 2010 UM

Multisite UC500

Route Internet Traffic through a RA IPSec VPN Tunnel

Re: Unable to bring up Site2Site VPN on 2 ASA's both running 9.8(2)

CME 8.6:SIP PSTN Trunk Cannot forward to Exchange 2010 UM

Multisite UC500

Multisite UC500

Spanning-Tree help needed