About calopez

calopez · 02-26-2003

Hello, I would like to perform a NON-INTRUSIVE testing of a backup-interface..but I am not sure if removing the Backup Interface command from the Primary interface will cause disruption..i.e. routing switched to backup, etc.Here is the config.. Has ...

calopez · 02-24-2003

I am trying to get an ISDN connection established BUT it is failing on CHAP authentication. I removed Tacacs from the router and CHAP worked fine..session established ok. There are NO AAA statements for PPP.. But how can I force the ISDN connectio...

calopez · 02-06-2003

Hello, I issued a SHOW IP ARP command on a router and noticed the field under the interface was "blank" and under Age column had a (-) hyphen.. Does this represent an issue or is this "normal" , all other addresses displayed had the entries filled ...

calopez · 02-04-2003

when using Reverse Telnet to a DSU I get the following message:% Insufficient memory; try again later Has anyone seen this message before?Thanks in advance!!Carlos

calopez · 10-24-2002

Hello,I ran a debug isdn q921 and need some pointers on how to intrepret the INFOc message below.I am interested in understanding what the INFOc message is saying below and also where in CCO I can interpret similar messages in the future.Thanks in ad...

calopez · 02-26-2003

thanks for the reply. I meant by non-disruptive that no production traffic would flow over the backup link.. But since the backup Serial1 link has a lower cost than the primary link, then that would mean that OSPF will try to route production traf...

calopez · 07-09-2002

I think I found my answer. When using LOCAL option in the AAA authentication login..a USERNAME must be specified. Since the router has no username coded then access is most likely disabled until Tacacs is back online or password recovy is attempte...

Member Since	‎04-05-2002 07:18 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	11

User Statistics

User Activity

non-intrusive test on Backup Interface.

PPP CHAP AUTHENTICATION not working.

display in SHOW IP ARP is blank under interface

getting error message when using Reverse Telnet

how to read info messages on ISDN.

Re: non-intrusive test on Backup Interface.

Re: AAA login local with no username.