Hi I have Cisco 3660 with analogue modem (NM-8AM-V2) as RAS, when i connect over PSTN the speed is always under 33,6K. also when i type show modem configuration i see the max speed 33,6can someone help how to avtivate V90/92 on this modemthx
HiI have TPE that connect on cisco 2600 router over PSTN on asynchrone interface. The TPE use x28 transpac mode, i coudn't activate this mode on the router, i tried with parametre X3 (6:9) but it didn't work.can anyone help me to activate this modeth...
Hican i backup FR subinterface with X25 subinterface with the command backup interface ?it work with X25 interface but with X25 subinterface the router don't accept the command, i don't know if it's a bug or this feature not exist.thanks
HiI have 3660 router with E1 as PRIthe configuration is :controller E1 4/0 pri-group timeslots 1-31!interface Serial4/0:15 no ip address encapsulation ppp dialer map ip 1.1.1.2 71869912 dialer-group 1 dialer pool-member 1 isdn switch-type primary-net...
Hii have stack of cat 3550 switches with GIBIC STACK module, i have many Vlans distributed on this stack, do i have to configure Gigastack port with trunk ? thx
Thx for the reply, this is the configthe TPE work only with french language so we have to activate transpac mode.TPE#show running-config Building configuration...Current configuration : 1914 bytes!version 12.2service tcp-keepalives-inservice tcp-keep...
Hi the debug that you demand are :tunrtc13#show debuggingDial on demand: Dial on demand events debugging is onPPP: PPP authentication debugging is on PPP protocol negotiation debugging is onISDN: ISDN Q921 packets debugging is on ISDN Q931 packe...
Hi Thanks for the replythe others side is OK because i tested them with my second router and they work fine so the problem is in the Cisco 3660.the other side is configured with simple dialer over BRIthx
HiThanks for the reply sorry the config that i possted is wrong there aren't the dialer map, i tried with the tow possibility, with dialer map and without and didn't workalso i tried with " dialer remote-name " and the same casewith debug i see that ...
Hinot necessairly brodcast only can cause loop, any paket can create loop.physical loop cause trouble in mac table, the switche find that Mac address is connected to tow different ports so il send the packet to port and the other siwtch resend it fro...
