About maroyal

maroyal · 10-17-2003

WLSE 2.0.2 software running on an 1105. When I go to Administration, Discovery, Run Now, I put in my seed device and hop, press finish and get a message indicating the report ran. I press okay, and go to view the reports but they are not showing. The...

maroyal · 05-12-2003

I have a 7206 and a 2621 connected by point to point over frame-relay. I couldn't get to the 2621 with IP so I decided to check layer 2 connectivity and did a "sh cdp neigh detail" I was surpised to see the 2621 show up as a switch in the capabilit...

maroyal · 05-09-2002

Anybody know where I can dowload version 2.5?

maroyal · 10-17-2003

I did the SNMP reachability test and it showed SNMP objects for the switch and AP. I don't see the devices in the managed/unmanaged devices list. I have a TAC case open. They want me to upload some log files on Monday. I think the TAC engineer is stu...

maroyal · 10-17-2003

it's been a couple of hours. I'm only discovering 1 AP and 1 switch. Discoveries 31-34 were instantaneous.

maroyal · 05-15-2003

In the test environment, this action of removing the "R" seemed to make sense, but this is not consistent along all 12.x versions of the code. In most versions of IOS, the router is still seen as a router. Also, on the production 2621s, CDP is seeing...

Member Since	‎05-09-2002 09:00 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	6

User Statistics

User Activity

WLSE not showing reports

Strange CDP neighbor output

IDS Software version 2.5

Re: WLSE not showing reports

Re: WLSE not showing reports

Re: Strange CDP neighbor output