About gtsesmelis

gtsesmelis · 01-07-2016

Hi All, I have a scenario that goes like this: I have an IPSEc site to site VPN between a router with network 192.168.1.0/24 on Site A and a Cisco ASA 5525 with network 192.168.2.0/24 on Site B. When we setup the server with ip 192.168.1.10 to send ...

gtsesmelis · 12-07-2015

Hi team, I have a failover Cisco ASA 5525x with SFR module with ip configured working through ASA management 0/0 (is our Backup SFR) It is connected to an access switch port. It was working as expected and I was able to ping the IP until a week ago...

gtsesmelis · 12-03-2015

Hi all, In this scenario we have 3 cisco devices: 1st Cisco Router connected to another 2nd Cisco Router with IPSEC site to site VPN and the 2nd Cisco Router is connected with IPSEC site to site to 3rd ASA firewall. 1st Router has lan netwo...

gtsesmelis · 06-04-2015

Hi team, we have two ASA 5525X in failover mode with SFR installed on them and Firesight in a Linux VM which the two SFRs are registered. We use to have the secondary ASA off cause if the primary fails we have to Turn on the secondary and switch manu...

gtsesmelis · 03-28-2014

Hello,I have a problem when i try to use Apple Facetime when i connect to Cisco 887VA-W (Router: c800-universalk9-mz.SPA.153-3.M.bin,Access Point: ap802-k9w7-mx.152-4.JB4) with my i-phone 5s (version 7.1). When I'm connected to WiFi it does not conne...

gtsesmelis · 01-07-2016

Hi, looks like the problem was on the host. We tried to send the video stream on another host than 192.168.2.10 and it worked so the problem isn't on the IPsec site to site VPN side. Thanks a lot anyway!!!

gtsesmelis · 12-17-2015

Hi, I've checked everything you mentioned and it was ok. It was playing in the first place but suddenly stopped. I re-imaged the sfr of the secondary ASA and it works now. I will also proceed on updating the firepower modules on both ASA. Thanks a l...

gtsesmelis · 12-16-2015

-

gtsesmelis · 12-16-2015

also when i do show managers on sfr console i get: > show managers Type : ManagerHost : x.x.x.xRegistration : Completed>

gtsesmelis · 12-16-2015

I was able to run the command after entering experts like this: sudo /etc/rc.d/init.d/network restart I got the following result: admin@Sourcefire:~$ sudo /etc/rc.d/init.d/network restartPassword: 10G[ OK ]ng default route10G[ OK ]ng address on e...

Member Since	‎03-11-2009 03:21 AM
Date Last Visited	‎07-02-2020 10:53 AM
Posts	23

User Statistics

User Activity

Sending udp video stream from a server on site A to a host to Site B

Cisco ASA 5525x SFR module not communication through ASA management 0/0

VPN connectivity between three devices

Problem with Secondary Cisco ASA 5525X SFR and Firesight

Cisco 887VA-W and i-phone 5s problem with Apple Facetime

Hi,

Hi,

also i can see that on

also when i do show managers

I was able to run the command