I have successfully (after 3 days!!!) managed to register a Nortell 1120e with my CUCM (Version 8.0.3.20000-2).I am able to make calls and use the standard soft keys associated with the Standard sip profile.The phone itself was set up as a 'Third Par...
I am currently looking at a proposed use of a couple of route map configs and wonder if anybody could help with a question i have.in the route maps there is an standard ACL configured to allow a specific networks traffic. This ACL is them picked up u...
I wonder if any body could help me out, i currently have a voice lab set up with a couple of ip phones, an old 2950 switch with a couple of VLANS set up (Vlan10 for Voice and Vlan 50 for data)this is connected via its fa0/9 (set as a trunk port) to a...
I wonder if somebody could solve this mystery for me. I am attempting to set up a Voice Home lab,but have run into an issue at the first hurdlei have a 2950 12 port switch, that i have set up voice and data vlans on ( see config below) with int fa0/9...
I am trying to configure a site to site ipsec vpn with 2 cisco 5505 ASA's. Unfortunately when i open up the ASDM there is no vpn wizard to start the configuration.The version of ASDM i am using from flash is 645-206.bin and the firmware on the ASA's ...
Jose,thanks for your reply, thats exactly what i was afraid of, and understood it to be,here is what the policy looks like...access-list 22 perimt 192.168.32.0 0.0.0.255route-map TEST1 permit 10match ip address 22set next-hop xx.xx.xx.xxip policty r...
Thank you all for posting your replies.I have managed to resolve my issue at long last, and a bit of a simple one at that.As mentioned previously i noticed that the physical NIC on my CUCM box did not have a default gateway entry, hence why it could ...
Made a bit of progress. I re checked the physical NIC in the machine thats running CUCM and noticed that there was no Default Gateway allocated. I have added the details of the Default Gateway to that NIC (The ip address of the 2801 facing CUCM) and...
thanks again,from CUCM OS Admin i can ping the routers interface with no problems., however i am unable to ping the subinterfaces address....here lies the problem.Chris
thanks again..i can confirm that the CUCM is concected via the pc NIC card and is on the same subnet as the Routers facing interface. i can ping the CUCM from the router with no issuesChris
