I tried to downgrade Nexus3048 and run into bootloader. Following commands took place and following eror message.Cant log in and palce command install all. Did several recovery tasks, nothing was working.Help is highly appreciated.Following the comma...
Hi all,Need some suggestion. Has an UCS environment, two FIs one Blade Chassis 6 Blade Servers, 2 Servers with 256Gig Mem and 4 with 128Gig Mem.2 Servers with 128 and two servers with 256 Gig working correctly from the beginning. Then we tried to add...
I have Nexus 5548UP, Version version 5.0(3)N2(2b), with a flat configured network. Customer has put several IP subnets on one Vlan. In one subnet is an Siemens SPS wich connects to a Server. This SPS is not reachable since I send a ping from the N5k,...
Hi,I have a problem to get the ASDM running on an ASA 5510. Sofware is asa804-k8.bin, ASDM is asdm-613.bin. Was also trying with asdm-615.bin but the same problem. On a previous version the ASDM was working fine (asa723-k8.bin and asdm-523.bin). I...
Hi,I have a problem with a 7970 phone registered to a CCM 4.2.(3)sr1. When I try to change the settings on the phone and update the config, I get the failure `url too long'. In some earlier surches I found in bug <CSCsg22098> to upgrade to version 4....
Found the solution. In that case I only had to boot nxos bios update and everything went well. See below.loader> boot tftp://192.168.68.101/nxos-n3kbios.binBooting kickstart image: /nxos-n3kbios.binrobin-2-Setting mac-addr to fc:99:47:54:cc:20shptr->...
Well, I found the problem. Customer had duplicate IP addresses for the 2 Blades which were added. I was a bit confused that 2 addresses from the KVM range were double.
Thanks for the reply, but where to find this release? I checked the download DB of Cisco but didnt find!? In the past it something like ciscocm.4-2-3-sr1.exe for example.
