Hi,
I have device c0, c1, c2, and want to configure c0 and c1 from NSO cli. If I use the following wildcard, it would catch c2 as well which is unwanted:
admin@ncs(config)# devices device c*
admin@ncs(config-device-c*)# config
admin@ncs(config-c...
Introduction
When doing SSL termination on ACE, there are times when the rserver might not have knowledge that the client only see https and would send a HTTP redirect with a http link (instead of https). This would inadvertently cause the clien...
Thanks, both of these solution would do the job!
Device-group would have been ideal, but somehow the config option is not available with it:
admin@ncs(config)# devices device-group dg1admin@ncs(config-device-group-dg1)# config----------------------...
The TAC case is resolved. Posting back to the community so the solution can be shared with a wider audience.Thanks to Mohammed for keeping outputs of troubleshooting at the time of problem, it was found that after the standby ACE rebooted, BOTH the ...
Hi Mohammed, I am already working with you on a TAC case on this issue, and noticed you've started this thread. I'll post out the resolution when our TAC case is resolved.Regards,Simon
Vlan 106 is missing "access-group input PERMIT-ANY", adding this fixed the ping problem from servers.Reason for adding the access-list on the server side interface is because the server ping first comes into the ACE via the server side Vlan, hence re...
