About Adeel Hasany

Adeel Hasany · 01-22-2017

Hi All We are trying to Migrate the our customer circuits from ATM interface to Ethernet without minimal disruption. We have around 20 odd customers hanging off the that ATM interface, each sub interface is for each circuit. What will be the best mi...

Adeel Hasany · 04-20-2016

Hi, I have a Mitel phone looking to pick IP from the remote DHCP server. But it get stuck on discovery DHCP. Upon debugging ip dhcp server packets I am geting following error: Apr 20 09:21:14.175: DHCPD: client's VPN is .Apr 20 09:21:14.175: DHCPD: ...

Adeel Hasany · 04-05-2016

Hi, We have remote sites in different part of the world and a management platform which has Wireshark installed (but we never used it) Is there a way to monitor the remote ports over the WAN from this management platform. Management platform is in E...

Adeel Hasany · 11-12-2015

Hi, Could any one please advise if there is a way to enable Ip accounting on ASR 1001? Ta Ad

Adeel Hasany · 10-12-2015

Hi All, I have a situation where customer asked me to split 10 Mb WAN circuit to 6 Mb and 4 Mb for the hosts from the same subnet. There are two different departments and due to some reason we cant split them into two networks at this stage. Is there...

Adeel Hasany · 01-22-2017

Hi Reza, Thanks I am actually looking for a solution infact.. I need a solution to migrate customer off from ATM to Ethernet. any idea how can that be possible. Thanks Ad

Adeel Hasany · 11-16-2015

Hi thanks but thats the defination. I need to know how can you run it on ASR 1001. becuase the commands are not available any idea?

Adeel Hasany · 10-15-2015

As Joseph advised a traffic generator would do the job... Also if you have access to the router you can also check the bandwidth .. by the way Ipref and prtg are your good friends..... https://iperf.fr/ Ta Ad

Adeel Hasany · 10-15-2015

Hi Greg, Re apply that policy onto dialler interface. do sh ip int br to see what virtual-access you get then run sh policy-map inte virtual acce X you would probably get either suspended mode error Service policy XYZ is in suspended mode I will be...

Adeel Hasany · 10-14-2015

Hi,Double check on the Atm interface rather then a dialer interface. Also try to put the service policy on the physical ATM interface. Also worth checking if the QOS is not on a suspended mode. sh contr vdsl 0 to see what upload speed you are gettin...

Member Since	‎06-10-2002 02:02 PM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	13

User Statistics

User Activity

Migration from ATM to Ethernet

Option 125 invalid

Monitoring VLANs or ports over the WAN

IP accounting on ASR 1001

Splitting bandwidth between different hosts

Hi Reza,

Hi

As Joseph advised a traffic

Hi Greg, Re apply that policy

Hi,Double check on the Atm