About bbinion80

bbinion80 · 10-23-2013

I have a 4507 and I have the ports configured for full duplex. The routers connected are also set for full but for some reason, the switch keeps negotiating to half-duplex. Maybe this is a common issue with an easy fix but I can't seem to figure it...

bbinion80 · 07-08-2010

I am using Cisco AnyConnect client v2.5 on a Windows 7 64 bit OS. If I restart the laptop, I am able to connect with no problem. If I disconnect for any reason and try to reconnect, I am given the error "VPN User Interface has stopped working." At...

bbinion80 · 02-11-2009

Greetings,We have two ASA's that will be used for VPN access. Initially only IPSec connections but eventually, we'll be using the SSL Web connections as well. I was curious which failover configuration would be more appropriate. Active/Active or the ...

bbinion80 · 10-15-2008

Greetings,I am attempting to set up dot1x using the certificates on our CAC cards to authenticate. I have been able to set this up where when the smart card is inserted into the reader and after entering your PIN, the system will authenticate and le...

bbinion80 · 10-07-2008

Greetings,I am attempting to set up a 2800 series router for dial up access. I would be using Windows XP to set up a connection, via the modem, to the router. I am able to reach the router and begin handshaking but when it goes to authenticate my u...

bbinion80 · 10-23-2013

Thanks for your help guys...I did have the speed set to auto. Once I set the speed, the ports reset to full. I don't think I've had to do that before but I honestly can't remember. Anyway...thanks ain for your help.

bbinion80 · 02-12-2009

Yeah I was looking at Active/Standby but my boss feels that if we are using it for VPN (IPSec and SSL) he thought one unit may be doing too much and would rather have some type of load balancing in place. So it seems the VPN cluster may be the best ...

bbinion80 · 02-11-2009

So if I am understand what you are saying correctly, I cannot use Active/Active while using remote VPN. I'd have to use the VPN Load Balancing to utilize fault tolerance. Is this correct?

bbinion80 · 10-07-2008

I have MS-CHAP-v2 enabled under global authentication along with v1. Its still behaving the same way. I am authenticating against Active Directory so it does allow MS-CHAP-v2 according to the chart.

bbinion80 · 10-07-2008

Thank you very much, this chart has helped. I am able to get it to authenticate using PAP. I had one more question that maybe you can help with. I was going to try to get it to authenticate using ms chap v2. For some reason, that is not working w...

Member Since	‎11-21-2007 05:31 PM
Date Last Visited	‎01-10-2021 04:15 PM
Posts	22

User Statistics

User Activity

Duplex Issue

AnyConnect client keeps crashing on Windows 7 64 bit

ASA Active/Active or VPN Cluster

Dot1x w/ CAC Card

Dial up Authentication Issues

Duplex Issue

Re: ASA Active/Active or VPN Cluster

Re: ASA Active/Active or VPN Cluster

Re: Dial up Authentication Issues

Re: Dial up Authentication Issues