Hi All,Today i am doing a POC to test R2 interoperability between Cisco 2801 (VWIC-2MFT-E1-DI + VIC2-2FXS + CP-7940) with Lucent Definity G3 PBX. I used and followed config guide from http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis...
we have two callmanagers 4.1(3), publisher and subscriber. we tried to register IP Phone A to publisher and IP Phone B to subscriber. after successfully register, IP Phone A can not call IP Phone B or vice versa. Does anyone know this behaviour?FYI, ...
I just upgrade Cisco CallManager 4.1(2) to Cisco CallManager 5.0(2). I can get access to callmanager administration page, disaster recovery system page and platform administration page but not callmanager serviceability page. It says access denied wh...
I just implement CMC code to restrict users being making calls without enter the CMC code. But I faced problem that when the users prompted to enter the code or password, the code appears so anybody can see it. Does anybody know how to make that pas...
Hi,Thanks for your suggestions. We will consider to try it.Anyway, after make change on Incoming MFC Forward Signal I-12 to 'end-of-ani' (which is not wrote in Cisco guide) on Avaya PBX then everything is now going fine. ANI is now appear on both Cis...
Hi,E1 controller config:!controller E1 0/1/0 framing NO-CRC4 ds0-group 1 timeslots 1-15,17-31 type r2-analog r2-compelled ani cas-custom 1 country argentina use-defaults metering!When I change to non-compelled, calls can't established at all.
Hi All,I want to make correction. I said on previous email, The issue is Avaya's ANI is not shown on Cisco IP Phone. The correct issue is Cisco' ANI is not shown on Lucent phone.sorry for this misunderstanding.Regards,Edi
