Result of the command: "show run": Saved:ASA Version 8.0(2) !hostname asadomain-name enable password namesname 192.168.1.33 VPN!interface Vlan1 nameif inside security-level 100 ip address 192.168.1.1 255.255.255.0 !interface Vlan2 nameif outside secu...

I have a 2600...With T1 to internet..also have DSL but it goes into its own DSL Router...so I have an ethernet connection to the second Ethernet connection on the 2600.... There is no NAT running on the router...I have NAT being done by a PIX....what...

Not looking for a Complex solution........I have a T1 with bellsouth and a DSL line for bellsouth...I have the T1 set up on Serial 0/1 with one static route.....I have the DSL connected to Ethernet 0/1 with a crossover cable going to the DSL Modem.....

I have a pix 6.3 when I use the Cisco VPN Client software to connect to another companies VPN.....it connects and gets an ip on the inside of there network but it will not pass packets....it works fine out side of the PIX any Ideas?

Firewall has fixed IP on untrusted and PPTP configured and running with local username and password list and a small pool of Ip's.....worked great untill I brought up an IPSEC VPN with the following commandsisakmp enable outsideisakmp policy 9 authen...