I have been looking around at our 6509E and noticed that the peak utilization on Module 5 (the active SUP) was at 98% (by show platform hardware capacity fabric command ).I'v check the peak bandwidht capacity of the 2 10G ports that build in on the S...
hello,My customer want to apply PACL to output interface (phisical interface/etherchannel interface, access or trunk mode) on his 6500 but the only option it has in the configuration is to the input interface.Is there a hardware th...
hello,I need to make a network design that includes unicast application that requires very little latency and broadcast application .Every application is on different vlan but all vlans are on the same switch.I need something cheap, that's why I put ...
I have a few edge sites with analog phone and I have central site with analog PBX (LG PBX)I would like to connect analog phone to analog PBX over the internet.the requirements of the edge site are:* adsl connection to the internet*one tunnel IPSEC* u...
hi,We have to connect multiple data E1s to ASR1002. Can be SPA-1XCHSTM1/OC3 interface (SDHmode) used instead of using multiple E1 interfaces, ( I mean "63subinterfaces").Following protocols used: GRE, IPSEC, EIGRP.Please see attach diagram:
hi Paliwal,it will take some time because it's a closed secured network without internet connection.meantime can you explain please how power is realated to the fabric utilization
suppose I have 11 2960s switches connected to 3750x stack.and in each of the switches I have one user that sends broadcast of 0.2M and recieve from all other users.in addition,in each switch I have 30 other users with 5 other vlans sending unicast (...
Can you explain how is it depend? for how much data? for how many users? how is it affect in case servers and the users connected to different switche?Is broadcast pakets affect differently from a multicast packets on the switch?