Hi,
I`m searching for more technical information for BE7-M5 hosts like
- Max. power consumption
- Max. BTU/hr
- RAID setup (BOM shows number of 300GB HDDs and RAID5, but not how many datastores and which size is available)
I`ve searched a lot on cisc...
Hi,
Customer wants to have G.729 as codec for all Audio calls, therefore Parameters Intra- and Interregion Max Audio Bit Rate are set to 8kbps. That works fine.
For Video calls they want to have AAC-LD as Audio Codec. But although AAC-LD ist on 1st...
Hi all,
customer wants to know all requirements regarding Network for a CUCM Environment. In SRND there is the following information:
Unified Communications and Collaboration over an IP network places strict requirements on IP packet
loss, packet d...
Hello, I`ve got a CUCM 9.1.2 connected via SIP Trunk to two other PBX. When I have a call between two CUCM Phones (eg. DN 2001 calls 2002) and I start a transfer from DN 2002 to 5001 (on 3rd Party PBX) the number (and name) 2002 is signalled on call...
Thank you, but the RAID information is quite old. Fortunately I meanwhile found info for M5 and M6 on Cisco Collaboration Infrastructure page when expanding hardware examples.
Regarding power there is only info about max. power supply wattage, but no...
Hi Jaime,
I think you are talking about something different, or? Because in the Release notes there is only the following part regarding New Media Player:
Support for Media Player
With Unity Connection 11.5(1) and later, Media Master is replaced wi...
Thanks for the answer, but this is not really a good solution. That would mean to configure an additional Region for all Locations where I have Video devices. And when a Jabber changes from Audio-only mode to Video config has to be changed etc. This ...
I`ve got the same problem. And when setting FIPS mode to false in AnyConnectLocalPolicy.xml I get the error message: "The VPN GUI and Agent Process are not both in FIPS Mode,"
Edit: New error message is gone after reboot. Now it works.
Regards
Juerg...
