Hello,I have a router 2600, IOS IOS (tm) C2600 Software (C2600-I-M), Version 12.3(10), RELEASE SOFTWARE (fc3).Memory:28672K/4096K bytes of memory.32K bytes of non-volatile configuration memory.8192K bytes of processor board System flash (Read/Write)T...
Hello,I have a Cisco router 2600, which I use for my training lab setup. I typed write erase to start up a new configuration but the router did not come backup. I have an identical router and tried swapping flash and dram, but it did not work. Please...
I am working on configuring communications Router to Router through serial port. I have seen some videos and read some documentations. My configuration is as follows: R1 (DCE) -> f0/0 192.168.1.1/24 - s0/0 192.168.2.1/24 <-----> Router2 ->(DTE) S0/1...
I am working on configuring communication Router to Router through serial port. I have seen some videos and read some documentations. My configuration is as follows: R1 (DCE) -> f0/0 192.168.1.1/24 - s0/0 192.168.2.1/24 <-----> Router2 ->(DTE) S0/1 ...
Actually I was just able to delete and install the original IOS, after adding more memory to the router. ThenI erased the configuration and also deleted the IOS from flash. I reloaded the original IOS through XModem from my ftp server.I got the route...
Thank you very much, Salman.The only problem is that the router keeps in loop during the ios load process. I can't get any prompt.Any idea, please, of getting into ROMMON or any command prompt? Thanks again.
Yes, my representation should be like this:R1 (DCE) -> f0/0 192.168.1.1/24 - s0/0 192.168.2.1/24 <-----> Router2 ->(DTE) S0/0 192.168.3.2/24 f0/0 192.168.2.1.As for the rest, the configuration is the same. I cannot ping from any host to the adjacen...
Adding more information to give a better view:Router 1 ip route:C 192.168.1.0/24 is directly connected, Ethernet0/0S 192.168.2.0/24 [1/0] via 192.168.3.2C 192.168.3.0/24 is directly connected, Serial0/0=======================================...
