About PWIjoshtorres

PWIjoshtorres · 11-15-2014

Looking for help with a certain issue... We have 2 circuits into our location, 1 for data side and 1 for VoIP. Currently - the data side is used a failover for the VoIP but we need to manually fail them over when the MPLS goes down. Is it possible to...

PWIjoshtorres · 09-15-2014

We have 3 different models of Access Points in our organization:AIR-AP1262N-A-K9AIR-AP1231G-A-K9AIR-AP1242G-A-K9We need to move our security from WEP to WPA2 but need to make sure all 3 APs can support it.When in the GUI, I have a hard time believing...

PWIjoshtorres · 11-17-2014

Jody, thanks for all your help! One more question...Wouldn't this route (below) continue to push traffic out that interface?ip route 10.160.230.11 255.255.255.255 10.93.254.17 permanentOr would the lower metric "track 1 route" take care of that route...

PWIjoshtorres · 11-17-2014

I have attached both configs for the switch and the MPLS router...This is what I came up with for proper config....Am I correct?ip sla 1icmp-echo 10.160.230.11 source-ip 10.93.254.17frequency 10ip sla schedule 1 start-time now life foreverdelay down ...

PWIjoshtorres · 11-15-2014

After reviewing IP SLA, I have 1 major question...How do I configure the SLA on the MPLS/VOICE side while keeping our data through the Data ISP/MERAKI?I hope that's clearly worded...

PWIjoshtorres · 11-15-2014

Thank you very much for the response! This particular switch only has a few static routes. We are not redistributing routes through any dynamic protocol. It looks like IP SLA's are what I need to look at.

PWIjoshtorres · 09-24-2014

Guys, is this still the case? Have any changes been made in the 7 years since this ticket? We are looking to use our ASA 5505 as an NTP server but everything I read says NO....

Member Since	‎05-08-2014 08:21 PM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	7
Total Helpful Votes Received	5

User Statistics

User Activity

Possible to have weighted default route for a certain subnet? 3750x

Wireless AP questions on WPA2

Jody, thanks for all your

I have attached both configs

After reviewing IP SLA, I

Thank you very much for the

Guys, is this still the case?