About Larry Bernard

Larry Bernard · 02-10-2016

Hello, I have a situation I am trying to figure out where devices plugged in to switchports will show as empty when I run a sho mac ad int xx. For example: SWITCH#show mac ad int f0/5 Mac Address Table---------------------------------------...

Larry Bernard · 07-02-2014

Howdy,I have all my devices in the Device Work Center and most are synching completely. I wanted to start developing templates for devices and figuring out how to push images, minor changes and new fast deployments. When I go to push an image out to ...

Larry Bernard · 06-30-2014

ISE Version: 1.2.0.899 (Running in VMware)WLC: 5508 ver 7.6.100.0I have a WLAN created that uses dot1x authentication. The WLAN points to ISE for RADIUS AAA. I cannot get any windows computer to connect to it (7,8 or 8.1 tested), but android, ios and...

Larry Bernard · 02-12-2016

No.

Larry Bernard · 07-01-2014

Nevermind, I get it now. I found the answer spelled out right here: http://www.cisco.com/c/en/us/td/docs/security/ise/1-2/user_guide/ise_user_guide/ise_man_cert.html#pgfId-1171626

Larry Bernard · 07-01-2014

Thanks for your prompt reply. If I understand you correctly, the workaround is to essentially NOT use a wildcard certificate? Here is another thing. In the certificate operations section I moved EAP to the self-signed certificate and the behavior is ...

Member Since	‎05-14-2014 07:37 AM
Date Last Visited	‎09-25-2018 08:02 AM
Posts	6
Total Helpful Votes Received	5

User Statistics

User Activity

MAC Address not showing up in table

PI 2.1 - Howto push config/image?

12511 Unexpectedly received TLS alert message; treating as a rejection by the client

No.

Nevermind, I get it now. I

Thanks for your prompt reply.