About matthunt2063

matthunt2063 · 08-03-2017

I've been trying to SSH into one of my 7942 phones. I've re-flashed it with SIP firmware, and have the SSH user/pass set in the XML file. I can get in using the debug user, but whenever I try to get in using the "default" I get the following prompt: ...

matthunt2063 · 07-16-2017

I recently converted two phones over to SIP42.9-4-2SR3-1S trying to get them to register in Elastix. One issue I'm seeing is mk-sip.jar and g3-tones.xml are missing. I downloaded the firmware off Cisco's site, but these where not included. I need t...

matthunt2063 · 06-19-2017

I'm trying to get my clients connected to inside to route to the internet. My current set up is: inside: 192.168.10/24 outside 192.168.1.10 DSL: 192.168.1.254 Outside is connected to my DSL router. DHCPD is set up on inside, outside is static. When...

matthunt2063 · 12-23-2014

The last question I posted is almost 6 months old with zero support.I'm trying to get the 1-to-1 NAT working, but it just gives everyone outside the network "Connection refused". I've set it as follows:Always Allow Any Enabled Outbound (...

matthunt2063 · 07-16-2014

Wow. This post has been up for OVER 5 MONTHS. Hello Cisco? Anyone home? KNOCK KNOCK? I expected far better support for this, I have yet to even get this to work right. I've recently set up a domain of tpfnd.cat and am trying to route my five mul...

matthunt2063 · 06-20-2017

I did that, and I also realize after looking over my config I had both zones set to security of 0. So I set the inside back to 100. Not sure which did the trick, but I'm marking you a 5 & "correct answer"!

matthunt2063 · 12-25-2014

and even though I enabled debugging on the logs, viewing then shows nothing...I even made another policy that specifically has "debugging" checked for both System and Kernel, I've refreshed my remote page load repeatedly, and the logs are still empty...

matthunt2063 · 12-25-2014

Both are enabled...maybe that's the issue, I haven't found any documentation saying only use one or the other. From what I read setting up the 1-2-1 is also supposed to create the ACL, but it doesn't...

matthunt2063 · 12-25-2014

I had a Cisco TAC guy remote in and do that (removed the Outbound Rule), it actually worked for 24 hours. Then while I was at work the rv180 locked up, rebooted it, and once again I'm getting "Connection Refused" even using the IP http://172.13.47.1...

Member Since	‎07-16-2014 05:37 AM
Date Last Visited	‎08-18-2017 04:02 AM
Posts	9

User Statistics

User Activity

7942 SSH challange?

Needing mk-sip.jar and g3-tones.xml for 7942g

Routing to external network on ASA 5505 not working

NAT faliures, 1-to-1 DOA only DMZ works

1 to 1 nat not working!

I did that, and I also

and even though I enabled

Both are enabled...maybe that

I had a Cisco TAC guy remote